Alex Schwalbe

Before beginning the MySense flashing process, you will need the following components:Windows PC with WIU installedUSB C cable Step 1: Preparing the MySenseIf the device being flashed is not yet in...

To update software and firmware on 75F devices, a software tool called the Warehouse Installation Utility (WIU) is used. The software can be obtained from 75F, and requires two additional third-par...

Before beginning the Hyperstat Split flashing process, you will need the following components:Windows PC with WIU installedUSB C cable Step 1: Preparing the Hyperstat SplitIf the device being flash...

Before beginning the CM flashing process, you will need the following components: Flash Station PC Atmel-ICE tool Step 1: Powering and connecting the CM Remove the CM from the box, then connect t...

Before beginning the Hyperstat provisioning process, you will need the following components: Flash Station PC Atmel-ICE tool Step 1: Powering and connecting the Hyperstat Remove the Hyperstat fro...

Note: Before beginning the Smart Node firmware update process, you will need the following components: PC with the 75F flashtool installed Atmel-ICE tool M3 Hex Screwdriver Step 1: Powering and c...

This document will guide you through installing and setting up the Flashtool, the software package used to upgrade firmware on 75F devices. The following steps will assume no existing flashtool ins...

Note: Before beginning the Smart Node provisioning process, you will need the following components: Flash Station PC Microchip Power Debugger tool Smart Node Philips Screwdriver Step 1: Powering ...

Before beginning the Hyperstat provisioning process, you will need the following components: Flash Station PC Atmel-ICE tool Test Smart Node Test Wall Sensor Philips Screwdriver Step 1: Powering ...

Before beginning the Hyperstat provisioning process, you will need the following components: Flash Station PC Atmel-ICE tool Test CCU Test Smart Node Step 1: Powering and connecting the Hypersens...